THEMA:

Hallo Garsten,
Now Part2.

5.3) The fourth mixer revers the left engine for revers mode with 50% power.
The right engine has 100% power and the left with half power reversed.



SB is the three way Switch for flight mode controll.

That´s all, very easy or not?
An sample file is added too.
With greets

Harald

Yes it works... But
It does not work like my program, you will never turn without moving, as is the video. You will never turn slowly "sharp" because you cannot have one propeller forward and one backwards with gas stick slightly up when steering.

On the attached program see gas channels 8 and 9; inverter channels 6 and 7; steering ch 5
Go on servo visualisation
Choose mode 'mot. separ" with SA switch
Move right stick up: 2 inverters forward
Move right stick down: 2 inverters backwards
Move right stick to the right: 2 gas increase and one inverter forwards an one backwards (you will turn without moving)
Move right stick slightly up and right... observe gas and inverters.

That is what I want, without decreasing the number of output channels.

Lagaffe schrieb:

Yes ! Propeller backwards is not as powerful than forward....

In my case it was vice versa But it looked the same!

Kai

@harald:

Il you program you use 3 functions
- engine,
- engine 1,
- engine 2.
Engine is not used as an output for servo. So can only have 15 servo output instead of 16, because you cant have more than 16 functions.
Is it wrong ?

Function still missing in Jeti radio, is'nt it ?
As long as you begin to chain mixes you loose channels.
Virtual channels are really missing in this radio.

You don´t need dummy function = virtual functions, instead use the the right function curve for the flight mode for this function
and mix it directly. Sample Mixer Gasd to Gasd with the needed mixing curve. Remove the dummy functions and mix it directly is
the answer of your question.
I can´t help because my Switch Sa is a button and when I load your modell file I can´t see whitch mixer is active on each flight mode.

With greets
Harald