THEMA:

Video of today

Hola Nacho
There is no video attached

Have you made the modifications on the Rex and sat like mentioned before?

Or have you just put the sat on E1 of the Rex?

Again: I’m flying Gas planes just with an R9! No need for the Sat.
Just make sure that the yellow antennas are lying on the foil and not behind the wood.

What is the power solution and controller you are using?

I never used an extra Sat receiver over 10 years of JETI.
An extra Sat is a good choice for large expensive models, but imo it is not needed for standard models.

I looked into some logs from last summer.
With an electric glider the Q-Level is at 100%, with a REX-10.
Throughout the full flight I had only a few drops down to 80%. Distance range was up to 400m.

Never expect such low Q, as shown in your video.
Either you have a bad receiver (try onother) or the DS-16 is bad.

In either case contact your dealer and/or jeti.

best regards
Alois

Dear Nacho,

I would suggest that you do following:
1) remove the Rsat2 -> just use the REX7 in single mode not dual mode -> programm a safety Switch on the engine do prevent any unwilling run of the engine -> do a range test BEFORE you fly. If it works, there must be something wrong with the Setup of your Rsat2.

Please inform us about the result and be careful.