THEMA:

Hello
I'm crazy because I'm not able to configure Master Spin Pro 100 via DS16 emulation. I've no Jetibox for the moment but I see as a real necessity now.
I connect Lipo4S and the MS100 (attached to the motor with no propeller) to Ext on receiver.
No black plug connected to rx.
In this configuration I see on device explorer that pin Ext. is set to Jetibox.
Opening JB emulation on DS16 I reach only the point that the system is telling me " Mx connecting" but nothing more.

Is it absolutely necessary to have a Jetibox to settle MS 100 ?

Let me say that I'm not reading my mother language but probably user guide is NOT clear enough (???)

Thanks for your kind help, sunday I would like to fly........probably a Master Mezon was a better choice ?

Trying also to translate some other 3D, I've also connected a 6S Lipo to have more voltage.
Some users wrote to use a 5S voltage but I've only 4 and 6S packs, and I made a new EC3 to EC5 cable.

But also with more voltage.....MX connecting is flashing and it's all .

Hi Miko! My english is not the best, but I try to help you
What kind of receiver you are using? There was a problem with firmware V3.11 a few years ago.
Do you have another receiver for testing?

best regards
Dieter

Danke Dieter!

REX7 bought approx. june 2015. Now I check the version and I look if there are updates for it.

Thank you very much !

I do the necessary and I hope to come back with a positive feedback.

Danke again !

hello Miko,
in process of programming the motorchannel dont be used, use only one cable from controller to the receivers Ext.Port! If the controller detect PWm signal on the Motorchanel, they stopp any function (safety functionality).

Yes, I connect ONLY / NUR red cable to Ext - No/nein black cable connected!