Jeti Assist Einstellungen

MThonet wrote: Hallo wfield0455,

ich hoffe, Du kannst es mit Google-Translate lesen.

Wenn man den Assist mit dem Konfigurator einstellt, werden die Haken bei Quer, Höhe und Seite gesetzt.
Du schreibst, dass z.B. bei Querruder nur quer gehakt sein soll, Höhe und Seite ein X. Das konnte ich bisher
nirgends so lesen.
Die Wölbklappen habe ich komplett auf X gesetzt, aber in den einzelnen Spalten Querruder/Höhe/Seite den Standard gelassen.
Was ist richtig?

Herzliche Grüße

Michael

Michael,

Google translate does make things more difficult. By default everything is enabled but in reality the only things that should have a check mark are Aileron servos should have a check mark under roll, Elevator channels should have a check mark under pitch, the rudder should have a check mark under Yaw. This needs to be repeated for each Assist flight mode. Basically channels with a check mark under yaw will have corrections applied when the model yaws, etc. I'm not sure how big a problem it is to have none control surface channels enabled but they aren't needed and I'm concerned it may cause problems. To avoid any possibility of problems, I only enable channels for the axis that they correspond with. Everything else is disabled (x). This has worked well for me and my Assist flies perfectly. Hope this helps, or at least makes sense after Google is done with it :^)

Wayne

Hallo Wayne,
thank you for your helpfull informations.
I will correct my assist corresponding.

Michael