Willkommen, Gast
Benutzername: Passwort: Angemeldet bleiben:
  • Seite:
  • 1

THEMA: "mgps" et azimut

"mgps" et azimut 21 Feb 2015 11:41 #1

  • andre13
  • andre13s Avatar Autor
  • Offline
  • Fresh Boarder
  • Fresh Boarder
  • Beiträge: 4
  • Dank erhalten: 0
bonjour,



Today with the "m gps ex" it's impossible to know the azimuth of my glider .
With the azimut and the distance i can know the position of my glider.
I might steer the glider over a route tag.
I want to do a "triangle gps" witout a coach.
Is this option possible in the future ?

Sorry for my english.

André13

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Letzte Änderung: von andre13.

"mgps" et azimut 21 Feb 2015 14:23 #2

  • kukulle
  • kukulles Avatar
  • Offline
  • Expert Boarder
  • Expert Boarder
  • Beiträge: 104
  • Dank erhalten: 12
Hello André,

I do not know exactly where your problem is. I can only asume that you did not set the "sensor/Logging Setup" correct.
If you press "auto" again your MGPS will start again to send all data. But this can take up to 3 Minutes.

Then it should be possilbe to use and show up the Azimuth on the screen of your Jeti TX.
To increase the update rate on your screen you can switch into the menue "timers&sensors" - "voice output" - ""sensors & varaibles" - and then set the mandatory indications in the telemetry downstream (update rate) from "low" to "high".
I have done this for the indications Altitude, Distance, Speed and Azimuth and it works perfect.

Of course do not do that with all the telemetry information...this will cut down the overall update rate again.....simply for the most interesting and "urgent" parameters.

Good Luck to you,

Robert
intelligent airborne inspection

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Letzte Änderung: von kukulle.

"mgps" et azimut 22 Feb 2015 10:54 #3

  • andre13
  • andre13s Avatar Autor
  • Offline
  • Fresh Boarder
  • Fresh Boarder
  • Beiträge: 4
  • Dank erhalten: 0
Robert thank you,

This is the exact answer to my question.

Best regards

Andre13

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

  • Seite:
  • 1
Ladezeit der Seite: 0.141 Sekunden
Powered by Kunena Forum