we use gpsvisualzer program to look at the flight-path on a google map.
This works perfect, but we have seen somewhere in the past a program
that also put the flight-speed and altitude at the side of the map...
The program followed the plane from place to place as a movie.
Yes NicoS, we are dutch and have both the jeti transmittor ( of course...)
So, do i understand it right... make a flight, put the data in the sender, and then copy the data to a pc and then start jetistudio in that Pc?
The transmitter can store data while flying. These data are used for Jeti Studio.
The transmitter must be set to the required purpose. The best you can reading the manual, the chapter "Sensors / logging Setup".
Nice pictures as below are then possible.
The synthesizer in the transmitter can speak values, for example, height and speed. This can be periodically, for example every 30 seconds and / or after the flip of a switch.
Please note that the GPS altitude is not so accurate and the GPS speed is ground speed and not air speed.