logische Schalter kopieren

Hi,
gibt eine smarte Lösung, wie man logische Schalter, die man für ein Modell erstellt, hat auf ein anderes überträgt ?
Danke Klaus

You could possibly locate the section in the Model jsn file:
"LogSwitch":{"Type":"LogSwitch","Data":[{"Type":"Log-Sw","Index":0,"Enabled":1,"Label":"11","Switch1":"16,0,0,1,1,-4000,-1,0","Switch2":"17,0,0,1,1,-4000,-1,0","Cond1":1,"Cond2":0,"Value1":0,"Value2":0,"Log-Type":1,"Up-Type":0,"Dn-Type":0,"Up-Time":0,"Dn-Time":0} ....... and so on for each logical switch you see until the closing }]}'
and copy it into your new model jsn file.

Hallo ,

den Vorschlag von Greg würde ich nicht empfehlen ….

Dass wäre mir !! zu risikobehaftet .

Gruss
PW

 

I created a new model memory.
I replaced the Logswitch section with one from an existing model which uses logical switches.
When I select the new model after the copy all the logical switches are there and available to use.

thanks, yes I did it this way and it works fine. BUT it works for log switches, other sections has beed changed since latest SW release and they are not compatable !