Please some help programming capacity in a Unisens-e

Hello everyone!
I'm having trouble programming the Unisens-e so it continues to read the mah from the last flight.
No matter which setting I choose for "Capacity" every time I start it from 0. Since this is a glider, I'd like to measure the total capacity is left in the batteries, (or in fact how much I have used already) but the total adding all flights .
Everything else fine so I think the problem might be in some other setting but I can not figure it out where.
Any help is greatly appreciated.
Thanks,
Fernando

You need the PC program SM UnisensE-tool www.sm-modellbau.de/PC-Software
With this program you can change the way how the Unisens works with the capacity. After switching on count from zero or countin from te previous value. You can change it by Kapazitat on the left part of the screen.

Read also page 10 from the Unisens manual on this page www.sm-modellbau.de/Bedienungsanleitungen

Nico

Hi NicoS,
I did that but no matter which option I choose in Capacity being fortsetzen, immer weiter, or bei 0 starten. Everytime I turn off and on again it starts from 0
EDIT:
One thing I noticed is that the sensor led is blinking in sets of 6 instead of being solid lit like it mentions in the manual but I'm not sure what it means "timed measurement was started b y exceeding the current threshold" ???

Sent a mail with a problem discription to SM Modellbau www.sm-modellbau.de/kontakt.php
Greetings

Nico

I don't know what I did but I unmarked all the alarms that I didn't need and it seems to work now even though the led still blinks.
Thanks anyway!!!
Fernando