Jeti Box Profi Holding Bind

Hello Experts,

I have recently acquired a Jeti Box Profi.

I am using it in "Monitor mode" and have currently bound it to two models on each of two separate transmitters. Each has been given a different profile name.

The manual states that "Binding must be carried out only, if the transmitter and the JETIBOX profi have never been bound before. If the JETIBOX profi and the transmitter have already been bound at any time before, after switching on they will automatically start communication with each other".

I have found that my Jeti Box Profi will only connect to the last transmitter to which it was bound.

1) How can I fix this?

2) How many transmitters/ models can Jeti Box Profi bind to?

Thanks for your assistance.

Hi,
i don't think, this can be fixed. I asume, the writer of the manual wanted zu say, that once the JETIBOX ist bound to a transmitter, it will monitor the comunication of every receiver/model which is used with this transmitter and add a new profile for every found receiver.

However, die JETIBOX will only listen to the latest bound transmitter. Otherwise there would be a problem, if two transmitters (known by the JETIBOX) are active the same time. So you will need to bind the JETIBOX to the transmitter of your choice if you want to monitor the communication between this transmitter and receiver, but the JETIBOX will remeber the profile settings (sensor screens) for a receiver/modell. Thus there is no need to reconfigure the profile, if the modell/receiver is bound to a different transmitter.

Thanks for the explanation. It's good to know the logic.