RSAT with MIkado VBAR Error

As far as i remember correct, both of my RSAT 2 used direct as default config.

But not 100% sure.

But i know that i found somewere on the V-Bar forum that we should change to Computed with 20ms.

With DC-16 the RSat in Direct mode tries to output all 16 channels at a time (so the output period is then ca 30ms, even if there is selected the option By transmitter). So it is essential to limit the PPM to max. 8 channels. Then maybe By transmitter also possible?

any updates from jeti on this?

in speaking to vbar expert he felt if the error was caused by the wrong frame rate it would be more often/consistent. he felt the wrong framerate would not cause the error to only happen 2 times during flight.

Any thoughts?