Willkommen, Gast
Benutzername: Passwort: Angemeldet bleiben:
  • Seite:
  • 1

THEMA:

Rex Assist: Telemetry Data for Roll and Nick should be trim value corrected. 03 Okt 2020 23:05 #1

  • Thomas66
  • Thomas66s Avatar Autor
  • Offline
  • Senior Boarder
  • Senior Boarder
  • Beiträge: 56
  • Dank erhalten: 6
It seems with FW 1.13 on a Rex10 Assist the sensor telemetry data's for Roll and Nick are showing the pure sensor position, though they have been adjusted with trim values. At least I couldn't figure out if it's possible or not to adjust the telemetry data's manually with the trim corrected values.

Since you want to see the real position in a.e a lua horizon app of your plane and not from the (maybe a bit tilted build in Rx) sensor, the outgoing telemetry data's for Roll and Nick should be corrected by the trim values..

/Thomas

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Letzte Änderung: von Thomas66.

Rex Assist: Telemetry Data for Roll and Nick should be trim value corrected. 17 Nov 2020 18:06 #2

  • Thomas66
  • Thomas66s Avatar Autor
  • Offline
  • Senior Boarder
  • Senior Boarder
  • Beiträge: 56
  • Dank erhalten: 6
Meanwhile I figured out that the assist sensor trim values do have no effects anyway .(In the assist fly modes )

FW Assist 1.10 / Rex 1.13

/Thomas

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Rex Assist: Telemetry Data for Roll and Nick should be trim value corrected. 17 Nov 2020 18:25 #3

  • skyfreak
  • skyfreaks Avatar
  • Offline
  • Platinum Boarder
  • Platinum Boarder
  • Beiträge: 2946
  • Dank erhalten: 1445
sensor trim takes only effect in failsafe as far as I know
pre 1.12 e.g. 1.09 sensotrim was working in hoizont as well (tested)

rgds guido
Fliegergruss
GUIDO



_________________________________________________________
Too many dicks on the dance floor.
Too many dicks!​


Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Rex Assist: Telemetry Data for Roll and Nick should be trim value corrected. 29 Nov 2020 18:23 #4

  • Raf
  • Rafs Avatar
  • Offline
  • Expert Boarder
  • Expert Boarder
  • Beiträge: 133
  • Dank erhalten: 179
Only in fail-safe and 2D-mode for airplanes. In Horizon mode, it's better to reduce the Attitude-stabilization gains to make it useful.
Voltario T30, Touch Switch, MicroVario, AMS, SE6

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

  • Seite:
  • 1
Ladezeit der Seite: 0.196 Sekunden
Powered by Kunena Forum