Bugreport Stick/Switch Setup - DS16V2

Dear Jeti-Team,

a friend and me observed a bug with Version 5.05 and 5.06 (both Jeti DS 16 V2). In Stick/Switch Setup page, the logical direction of pre flight position for switch SB, SE, SG, SC is twisted. Another point is, that the displayed symbol for the actual switch position is twisted too.

Example: Switch SC is in backward position but displayed as on - pre flight switch position for SC is logicaly twisted aswell. If i define backward position as preflight setting, the transmitter starts in forward position only without the warning.

Hi,

anyone elso has this experience ?

My DS 16 V2 works correct.

Regards
PW

Hello PW,

we made some Whattsapp Videos to show and explain this issue. If you want please pm phone number to forward it to you or someone.

Edit: By the way, we found some forum topics here which are adressing this issue aswell:

www.jetiforum.de/index.php/4-jeti-sender...-nicht?start=6#11937

Hallo,

your link shows a discussion from 2013 !

Please make a video and try perhaps to run an update via Jeti studio. Even if softrware is actuall, run again an update, try and report.


Regards
PW

Thank you,

yes, the topic is from 2013...but it describes exactly our experience with this behaviour. It wasn´t common to us and would a later date change something? A new firmware update, even with the option "factory defaults" doesn´t change anything.

I guess I started to understand what is going on here. Please go to the Stick/Switch Setup page, choose switch SC, configure preflight position as "down / off" and try to start the transmitter in the down position - it´s impossible. BUT, i guess Jeti tried to rescue this case with the term "off". As you see in the graphical animation of this switch, backward position is on (check-mark) and forward position is displayed with a cross (off). In this case the logic follows the on and off position/naming, which depends on the selected switch. Some switches are logicaly programmed in the usual back=off and forward=on direction and some do not on DS transmitters! I GUESS this is the way Jeti took care about the "one firmare for all transmitters" philosophy. Maybe they had to turn some switches to take care about cable routing etc, so every switch should be configured as shown in the on mid off animation.

It would be nice to setup switch directions in this menu. Honestly, I know it´s not necessary because we can setup every function by moving the switch in the desired direction, but it would improve the usual logical understanding of switch positions.

Hi,

I would suggest to contact the Jeti support via mail with a video.

Regards
PW