THEMA:

Dear Jeti-Team,

Users have reported a glitch in the priority settings of the voice output.

RX-Voltage - High
Antenna 1 - Mid
Antenna 2 - Low

Above works fine and output for all three values takes place when triggered.

RX-Voltage - Low
Antenna 1 - Mid
Antenna 2 - High

With the above setting, the output for the Mid value is skipped. Output only takes place for the High and the Low value.
This has been reported also for more than 3 values, if you have additional sensors defined and apparently only happens, when the values are
set with high priority from bottom to top.
If you omit the Low value and set High, Mid, Mid, then all three values are announced, but then again the Mid values are announced from top to bottom, so a priority can not really be set.

This is only a minor glitch that does not affect the primary function, but one that you might want to have look at for the next release.

Thanks very much and keep it up !

Todde