THEMA:

Hi, I have the 2 Rsats bound OK to my DC16 V2.22 in double path mode using EX bus in Rx 1/2 port.
The CB200 shows in Device Explorer. V 3.12 firmware for Rsats and V1.1 for CB200. I only get 8 channels working.
The assignments in the DC16 and in Device Explorer show but there is zero outputs for 9 to 13.
What do I need to get more channels?
Thanks for you time.

Hi,

set the RSat´s up to more chanel than 8 !

- Go back to ppm
- than you can set in Device manager from 8 chanel up to 16.
- Make this settings and than back to EX.

Regards

PW

Hi,

I think you need to set the RX to 16 channel.

I still use the JetiBox ( Emulation ) for RX-Settings. Have a look into MainSettings - OutputChannelCnt. Set the value to 16 in both RX and everything should be ok.

gecko

All good now. I had initially done that and then reset them and of course forgot to redo it.
Thanks it is all working as it should now and am very happy it is solved before bedtime!

Hallo BANANAMAN ,

good to hear.


Regards

PW